Chunya писал(а):
Если с 5-пиновыми разъемами, то ниже - инфа о нем из сониковской конфы.
This AD/DA uses a Switchcraft 5 pin XLR connector with the following standard pin out. Pin 1 - Ground, Pin 2 - Right Plus, Pin 3 - Right Minus, Pin 4 Left Plus, Pin 5 Left Minus
The 1st three Dip Switches apply to the A/D stage
The 1st Dip Switch selects between consumer (down) or professional (up).
Here is a quote from the manual...
"The second and third DIP switches control the bit that designates sample
rate in the channel ststus stream. This bit may be "hard set" to 44.1 or
48kHz, in which case it will remain at that setting no matter what the
actual sample rate in use, it may be set to follow the selected sample
rates from internal or external clocks."
Switch 2 Down & Switch 3 Down = Channel bit Status - Unknown (AES), 44.1kHz
(CP-340)
Switch 2 Down & Switch 3 Up = 48kHz
Switch 2 Up & Switch 3 Down = 44.1kHz
Switch 2 Up & Switch 3 Up = Auto "The bit automatically follows the Sample
Rate"
Switch 4 selects the function of the WS connector (the converter can
generate WS)
Switch 4 Down = Word Clock Output (generates), Up = W Clock Input.
This switch needs to be up to sync to WS from the front panel rotary dial.
Switch 5 Enables or Disables the D/A section. The A/D performs better with
this off.
Switch 5 Down = Enable D/A conversion, Up = Disable D/A Conversion. The
manual states that its a "very small performance gain"
А на русском нельзя, а то ничего не понять