qtran24 писал(а):
Главное чтобы топикстартер про конструктив чёнить дельное написал, а то тут лохи в моём лице, ни динамику ни динамики правильно считать не умеют
!
На сайт сходить религия не позволяет? Русским же по-белому написано:
Цитата:
Tweeter: 1″ cloth dome. Tweeter has a large-diameter vent on its pole piece and a big aperiodic damping chamber that imitates an infinite baffle loading. The size of the pole piece across the driver surface area, increases linearity and power handling, while having exemplary frequency response. The tweeters are manufactured on a special production line under laboratory conditions.
Mid-bass: Twelve 6″ polypropylene, double-magnet driver, with a 3″ voice coil diameter. Extremely rigid structural physics and the piston-like action of this driver produce exceptionally quick transients and a complete absence of coloration. These drivers are run full-range in four independently tuned transmission lines. Each transmission line contains three drivers in a pressure driven design, mounted front to back. The rear drivers reduce backpressure on the baffle-mounted drivers, simulating a free air resonance while simultaneously increasing linearity and power handling.
Bass: Six 12” woofers loaded in parallel chambers in pressure driven configuration. The rear drivers reduce backpressure on the baffle-mounted drivers, simulating a free air resonance while simultaneously increasing linearity and power handling. The rear drivers are vented out the back of the enclosure through 4″ ports.
Enclosure: The extremely heavy enclosure becomes slightly wider as the speaker gets deeper on the bass enclosure and slightly narrower on the high frequency section. This minimizes parallel wall interactions, while increasing rigidity and stability.
Если многабукаф: динамики узаду и унутре, шоб узадовое давление уконтрапупить.